Logo

P2961 Engine Code Repair

Meaning of P2961 engine trouble code is a kind of powertrain trouble code and when the check engine light comes P2961 code on the first you should check is the gas cap. Pull over, retighten it, and take a look at the cap to see if it has any cracks in it. Continue driving and see if the check engine light turns off. Alternately, you can purchase a gas cap for about $3 at an auto parts store. All you need to do is take the old one off and screw on the new one. If you've already made it to the store, you might as well just replace it. While not car-threatening, it's good to take care of this right away to improve gas mileage.

P2961 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for P2961 code is occuring now you should check P2961 repair processes.
Now don't ask yourself; What should you do with P2961 code ?
The solution is here :

P2961 Possible Solution:

P2961 Engine

Air Conditioning Pressure Sensor (ACP) Insufficient Pressure Change Each time the A/C clutch engages, the PCM is looking for a pressure change in the refrigerant. If the change in pressure is outside of the calibration the DTC will set. A/C system mechanical failure Open ACP or VREF circuit A/C sensor damaged A/C system electrical failure A/C clutch always engaged Verify A/C system function, including refrigerant charge.

P2961 Code Meaning :

P
OBD-II Diagnostic Powertrain (P) Trouble Code For Engine

2
Fuel And Air Metering (Injector Circuit Malfunctions Only)

9
Engine Oil Temperature Sensor Malfunction

6
Cylinder 1 Injector Circuit Low

1
Shift Solenoid E Performance or Stuck Off

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

P2961 OBD-II Diagnostic Powertrain (P) Trouble Code Description

P2961 engine trouble code is about Shift Solenoid E Performance or Stuck Off.

Main reason For P2961 Code

The reason of P2961 OBD-II Engine Trouble Code is Engine Oil Temperature Sensor Malfunction.

P2961 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.